CARPAL - Cylindrical Poles - CARPAL - Poles for street lighting

Go to content
CYLINDRICAL POLES

Our cylindrical poles are made of steel sheet  S235JR (EN 10219-01).
Usually for this realizations are used as the specific diameters Ø 89 mm or the Ø 102 mm; poles of other diameters appear to be less recurrent but quietly achievable.
The closure of the top of the cylindrical poles is achieved by a bottom plate, welding in circumferential manner at the top of the pole, on that cap is subsequently welded centrally and vertically, a cylindrical sleeve Ø 60 mm for allowing the accommodation of the lighting fixtures or any other of our top accessory.

At each pole are made the following processes:
     -   cable entry slot;
     -   application of pocket grounding;
     -   terminal board slot.

The galvanization of materials is obtained by dipping into bath of molten zinc which thickness of the zinc coating is conform with UNI EN ISO 1461.

The poles are made in compliance with the UNI EN 40-5 and related regulations:
Dimensions and tolerances: UNI EN 40-2;
Materials: UNI EN 40-5;
Specification for characteristic loads: UNI EN 40-3-1;
Verification by calculation: UNI EN 40-3-3;
Surface protection: UNI EN 40-4.
Each post comes with adhesive label CE.


P. IVA e C.F.: 02839961212
Back to content