CARPAL - Special Processing on the Base of the Pole - CARPAL - Poles for street lighting

Go to content
SPECIAL PROCESSING ON THE BASE OF THE POLE



HEAT-SHRINKING SEATH BAND

It consists of the hot application at the base of the pole at the base of the base of a special coextruded cross-linked polyolefin sleeve, fitted inside an adhesive which thanks to the action of the heat adheres perfectly to the galvanized surface.




STEEL REINFORCED SLEEVE

The base of the pole can also be reinforced thanks to the application, of a cylindrical steel sleeve S235JR with a height of 500 mm, at the center line of the landfill point, fixed to the base of the pole by welding.
This application is carried out on the raw material which is only subsequently hot-dip galvanized in melted zinc tanks together with the pole.




BASIC PLATE (welded to the pole)

An alternative solution to the traditional burial of lighting poles is installation using a base plate.
This operation consists in welding at the base of the pole an adequate square plate perforated in steel S355, and if necessary, also the application of 4 triangular reinforcement ribs between the plate and the pole.
This operation precedes the hot dip galvanizing phase.
On request the base plate can also be made of a non-square shape.




GROUND ANCHOR KIT

Indispensable for a correct installation of the pole on a base plate, is the use of the GROUND ANCHOR KIT.
The KIT consists of a rough counter-plate with a thickness of 4 mm, n° 12 galvanized nuts, n° 8 washers and n° 4 raw bolts.


P. IVA e C.F.: 02839961212
Back to content